TM-9-2815-237-34

ENGINE, DIESEL: 8 CYLINDER, 6.2 AND 6.5, NORMALLY-ASPIRATED, DETUNED AND TURBOCHARGED

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JULY 2004

CHANGE 2

TM-9-2815-237-34 - Page 226 of 267

TM 9-2815-237-34

2-41. ENGINE ASSEMBLY FROM SUBASSEMBLIES (Cont’d)

x. Intake Manifold

1. Install two gaskets (2) and intake manifold (1) on cylinder heads (3).

2. Install injection line clip (10), three injection line clips (5), and fuel supply line clamp (11) on

intake manifold (1), following assembly diagram shown.

NOTE

Perform step 3 for 6.2L engines. Perform step 4 for 6.5L engines.

3. Install four long studs (6), long capscrew (9), six studs (7), five capscrews (8), and sixteen

washers (4), following assembly diagram shown.

4. Install four long studs (6), long capscrew (9), seven studs (7), four capscrews (8), and sixteen washers (4),

following assembly diagram.

2-182