TM-9-2815-237-34

ENGINE, DIESEL: 8 CYLINDER, 6.2 AND 6.5, NORMALLY-ASPIRATED, DETUNED AND TURBOCHARGED

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JULY 2004

CHANGE 2

TM-9-2815-237-34 - Page 220 of 267

TM 9-2815-237-34

2-41. ENGINE ASSEMBLY FROM SUBASSEMBLIES (Cont’d)

r. Rocker Arm Shaft and Pushrods

CAUTION

Marked ends of pushrods must point up when installed or engine

damage may result.

1. Install eight pushrods (1) in proper location with marked end of pushrods (1) up. Make sure

pushrods (1) are properly seated.

2. Install two rocker arm and shaft assemblies (2) on cylinder head (6). Make sure pushrods (1)

properly seat in rocker arms (3).

3. Secure rocker arm and shaft assemblies (2) with four retainers (4) and capscrews (5). Tighten

capscrews (5) to 41 lb-ft (56 N•m).

4. Repeat steps 1 through 3 for opposite side.

2-176