TM-9-2815-237-34

ENGINE, DIESEL: 8 CYLINDER, 6.2 AND 6.5, NORMALLY-ASPIRATED, DETUNED AND TURBOCHARGED

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JULY 2004

CHANGE 2

TM-9-2815-237-34 - Page 216 of 267

TM 9-2815-237-34

2-41. ENGINE ASSEMBLY FROM SUBASSEMBLIES (Cont’d)

n. Valve Lifters

WARNING

1.

2.

3.

4.

5.

6.

7.

Diesel fuel is highly flammable. Do not perform this procedure

near fire, flame, or sparks. Severe injury or death may result.

Submerge eight lifters (3) in clean diesel fuel or kerosene and work plunger (2) up and down with

pushrod (1) to prime lifters (3).

Apply OE/HDO to lifters (3).

Install lifters (3) into cylinder block (7).

Install four guide plates (6) on lifters (3).

Install two guide plate clamps (4) with two capscrews (5). Tighten capscrews (5) to 15-20 lb-ft

(20-27 N•m).

Repeat steps 1 through 5 for opposite side.

Manually rotate crankshaft (8) two complete revolutions to ensure free movement of lifters (3).

2-172