TM-9-2910-226-34
PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
JUNE 1974
TM-9-2910-226-34 - Page 135 of 208
TM 9-2910-226-34
Figure 3-157. Checking stop plate and smoke limit cam clearance
(code G pumps).
(3) Refer to figure 3-158. Install governor cover
gasket (A) and governor cover (B). Secure cover with
four machine screws (C) and Iockwashers (D).
Torque tighten screws to 50-60 inch-pounds.
NOTE
If the fuel pump is to be tested immediately
after assembly, the governor cover should
not be secured until adjustments are made as
described in paragraphs 3-50 through 3-58.
Figure 3-158.
Installing governor cover (code G pumps).
3-47. Installation of Timing Window Cover and Fuel
Shutoff Rod Assembly or Solenoid Assembly.
a.
Assembly.
The timing window cover and fuel
shutoff rod assembly were assembled during repair
(paras. 3-21 and 3-22).
b. Installation.
Refer to figure 3-159. Coat gasket
(A) with a thin coat of sealer, MIL-S-45180 or
equivalent on side facing cover. Install gasket (A),
timing window cover and fuel shutoff rod assembly
(B). Install two fillister head screws (C) and lock-
washers (D).
NOTE
If the injection pump is to be tested after
assembly, do not tighten the timing window
screws until the fuel leakage and timing
check as described in paragraphs 3-50
through 3-58 has been performed.
Figure 3-159. Installing timing window cover and fuel shutoff
rod assembly or solenoid assembly,
Installation
of Fuel Shutoff Solenoid
Assembly.
Install fuel shutoff solenoid assembly the
same as in
b
above except use two socket head screws
and lockwashers (E). Do not tighten screws and
install wire until after pump is tested.
NOTE
Gasket – 11662856 (0.020 thick) is a service
replacement for gasket — 7748841 (0.031
thick) and can be used with timing window
cover on any pump, but is a mandatory
replacement with the solenoid assembly on
code A injection pump.
3-89
Back to Top
