TM-9-2910-226-34
PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
JUNE 1974
TM-9-2910-226-34 - Page 57 of 208
TM 9-2910-226-34
Figure 3-27. Removing bearing retaining plate.
b.
Refer to figure 3-28. Place the pump housing
(A) on bed of arbor press. Position remover and
replacer on camshaft (B) and press the camshaft and
associated parts from the pump housing.
Figure 3-28. Pressing camshaft and associated parts from pump
housing using remover and replacer 5120-793-5055.
Caution
Support the pump housing so that the
timing pointer (fig. 3-27) will not be
damaged.
Section Ill. REPAIR OF FUEL INJECTION PUMP COMPONENTS
3-17. General.
a. Parts Identification.
Because of the
numerous pump models repaired in this section of
the manual a ready reference to parts is provided in
table 3-1. Parts in appendix B are coded the same as
the pumps.
(1)
Column 1, nomenclature.
Defines pump and
part name.
(2)
Columns 2 through
5. These columns list the
pumps as coded with the part number of the part
applicable to the particular pump. The numbers
indicated are the Army number, Federal stock
number,
and the manufacturer’s part number
(American-Bosch, FSCM 01843).
(3)
Column
6,
remarks.
Defines differences in
parts shown in columns 2 through 6 for the par-
ticular part, indicates optional parts, and also shows
parts available in kits.
b. Illustrations.
Figures 3-29 through 3-37 are
exploded views of the pumps and show the different
parts applications.
3-11
Back to Top
