TM-9-2910-226-34
PUMP, FUEL, METERING AND DISTRIBUTING, ASSEMBLY
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
JUNE 1974
TM-9-2910-226-34 - Page 53 of 208
b.
Refer to figure 3-16. Rotate camshaft until
slotted tooth of plunger drive gear alines with arrow
on injection pump housing. Lock camshaft in this
position using camshaft fixture.
TM 9-2910-226-34
d.
Refer to figure 3-18. Position puller (A) and
loosen timing device hub (B).
Figure 3-16. Locking camshaft using fixture–4910-870-2131.
c.
Refer to figure 3-17. Loosen camshaft nut
setscrew (A) and camshaft nut (B) two or three
turns.
Figure 3-18. Removing timing device hub using puller –
e.
Refer to figure 3-17. Remove camshaft nut
setscrew (A), camshaft nut (B) and timing device
hub .
f.
Refer to figure 3-19. Remove Woodruff key (A).
Figure 3-19. Removing or installing pump Woodruff key.
3-13. Removal of Hydraulic Head Assembly.
NOTE
Sub-Paragraph
a
below applies only to code
F and G injection pumps.
a.
Refer to figure 3-20. Remove oil filter screw (A).
Remove and discard filter screw copper gasket (B)
and remove oil filter (C). Or remove screw (D),
Figure 3-17. Loosening camshaft nut.
3-7
Back to Top
