TM-9-2990-205-34-P
TURBOSUPERCHARGER MODEL 5HDR
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 2005
TM-9-2990-205-34-P - Page 51 of 128
TM 9--2990--205--34&P
0010 00--1
INSPECTION OF COMPONENT PARTS
0010 00
THIS WORK PACKAGE COVERS:
Inspection
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0017 00)
Magnifier (item 3, WP 0017 00)
Gage, turbocharger (special tool) (Fig 4, item 1,
WP 0015 00)
Micrometer, outside (item 4, WP 0017 00)
Micrometer, outside (item 5, WP 0017 00)
Micrometer, outside (item 6, WP 0017 00)
Telescope gage set (item 7, WP 0017 00)
Equipment Condition
Turbo components on work bench; cleaned and dried
NOTE
All components not discarded during disassembly must be thoroughly inspected according to
the following procedures to determine if they can be reused in rebuilding the turbo.
Some defects you may discover during inspection can be repaired (WP 0011 00); however,
parts that are worn or damaged beyond repair must be replaced with new parts.
Wear standards for turbo components are provided within the applicable inspection
procedures. Use appropriate precision measuring instruments when checking for wear. When
measuring inside or outside diameters, always take two measurements approximately 90
degrees apart to allow for possible out--of--round condition.
When inspecting for cracks, use a strong light and magnifying glass.
Back to Top
