MWO-5-2350-262-35-4

ARMORED COMBAT EARTHMOVER (ACE), M9

MODIFICATION WORK ORDER

MWO-5-2350-262-35-4 - Page 113 of 207

MWO 5--2350--262--35--4

4--10

SECTION II INSTALLATION OF NEW FORWARD LEFT MANIFOLD

ASSEMBLY -- CONTINUED

4--4

INSTALLATION OF NEW FORWARD LEFT MANIFOLD ASSEMBLY

NOTE

Steps a and b below apply to Figure 4--4.

NOTE

It may be necessary to loosen valve coils on new forward left manifold assembly and

slide them away from manifold to provide wrench clearance. However, if clearance is

needed, to prevent damage to the coils, the coils should not be removed entirely.

a.

If necessary to provide wrench clearance, loosen (but do not remove) valve coils on new forward left

manifold assembly and slide away from manifold assembly.

b.

Install new forward left manifold assembly, 12496949, (1), in same manner as previously installed

forward left manifold that is being replaced, using two locking screws, B1821BH038C250L, (2) and two

flat washers, 10910174--3, (3). Refer to TM 5--2350--262--20--2, Hydraulic Front Manifolds and Fittings

Replacement, and to Figure 4--4, below. If necessary, valve coils may be loosened and slid away from

the manifold to provide wrench clearance. Do not remove coil entirely.

Figure 4--4. Installation of New Forward Left Manifold Assembly