SMI-9-2320-387-14P-1

TRUCK, UTILITY: EXPANDED CAPACITY

SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS

JULY 2004

SMI-9-2320-387-14P-1 - Page 172 of 671

11-49.12.

WEAPON STATION TRAY AND BRUSH MAINTENANCE

SMI 9-2320-387-14&P-1

11-98.14

Change 4

This task covers:

a. Removal

c. Adjustment

b. Installation

a. Removal

1.

Remove three locknuts (7), washers (3), capscrews (2), washers (3), and weapon station

tray (1) from bearing (5). Discard locknuts (7).

2.

Remove eighteen capscrews (10), washers (11), and three turret lockring sections (9) from support

assembly (8).

NOTE

Perform step 3 only if brush is installed.

3.

Remove brush (12) from tray (1). Clean out any sealant in brush mounting location.

NOTE

Note location of attaching hardware for installation.

Equipment Condition

• Weapon station hatch removed (para. 11-49.1).

• Hinge pivot bracket and gunner’s sling removed

(para. 11-56.2).

• Gunner’s sling hook removed (para. 11-56.1).

• Weapon station backrest pads removed

(para. 11-49.11).

• Weapon station hatch latch removed (para. 11-49.9).

• Weapon station hatch tube removed (para. 11-49.10).

• Turret lock removed (para. 11-59.3).

• Armament cover and seal removed (para. 11-59.5).

• Armament mount panel removed (para. 11-59.4).

INITIAL SETUP:

Applicable Models

M1151

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Materials/Parts

Adhesive (Appendix C, Item 4)

Three locknuts (Appendix G, Item 106)

Personnel Required

One mechanic

One assistant

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P