SMI-9-2320-387-14P-1

TRUCK, UTILITY: EXPANDED CAPACITY

SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS

JULY 2004

SMI-9-2320-387-14P-1 - Page 174 of 671

11-49.12.

WEAPON STATION TRAY AND BRUSH MAINTENANCE (Cont’d)

SMI 9-2320-387-14&P-1

11-98.16

Change 4

c.

Adjustment

1.

Loosen capscrew (6) securing support ring (1) to C-pillar support bracket (7).

2.

Check the gap between C-pillar support bracket (7) and support ring (1).

3.

Remove one slotted washer (8) at a time, as required, and rotate weapon station tray (9) to check

for binding. If there is no improvement, proceed to step 5.

4.

Add one slotted washer (8) at a time, as required, and rotate weapon station tray (9) to check for

binding. If there is no improvement, proceed to step 5.

5.

Loosen eight capscrews (3) securing two clevises (5) to windshield (2). Rotate weapon station tray

(9) to check for binding.

6.

If weapon station tray (9) rotation has improved, position adjustment slots (4) in clevises (5) where

weapon station tray (9) operated freely and tighten eight capscrews (3) and capscrew (6).

NOTE

If weapon station tray rotation has not improved after adjustment

procedures, remove turret bearing assembly.

7.

Install primary weapon system and check operation of weapon station tray (10). Refer to

TM 9-2320-387-10.

NOTE

• Do not adjust weapon station tray if loose or damaged.

• Weapon station tray needs adjustment if it binds, sticks, or does

not rotate freely.

NOTE

• If gap is the thickness of a slotted washer or greater, proceed to

step 4.

• If no gap exists, proceed to step 3.