TB-9-2320-280-35-12
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR EPLRS NETWORK MANAGER VEHICLE WITH AMTECH TOP
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-12 - Page 33 of 162
TB 9-2320-280-35-12
5-9
Section IV. SINCGARS MOUNTING TRAY AND AMP GUARD INSTALLATION
4-1.
Remove paint from vicinity of four mounting holes (6) on integrated rack (7) and vicinity of four
mounting holes (5) on bottom of mounting base (4).
4-2.
Apply anti-seize compound to vicinity of four mounting holes (6) on integrated rack (7) and four
mounting holes (5) on bottom of mounting base (4) as required.
NOTE
Two lockwashers and one nut are used on driver-side screws only.
4-3.
Install mounting base (4) and amp guard (9) on integrated rack (7) with two capscrews (2), two
capscrews (3), six lockwashers (1), and two nuts (8).
4-4.
Place warning decal (10) on amp guard (9).
Figure 5-12.
1. LOCKWASHER – MS45904-72 – QTY. 6
2. CAPSCREW – B1821BH031F125N – QTY. 2
3. CAPSCREW – B1821BH031F100N – QTY. 2
4. MOUNTING BASE, MT-6352/VRC – A3013367-1 – QTY. 1
8. NUT – MS51968-5 – QTY. 2
9. AMP GUARD – 872842-1 – QTY. 1
10. DECAL – 861868-2 – QTY. 1
6
5
1
9
10
2
1
3
4
7
1
8
9
5
5
5
6
Back to Top
