TB-9-2320-280-35-12
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR EPLRS NETWORK MANAGER VEHICLE WITH AMTECH TOP
OCTOBER 2006
CHANGE 1
TB-9-2320-280-35-12 - Page 88 of 162
TB 9-2320-280-35-12
5-60
Section XXXI. SINCGARS ANTENNA CABLE INSTALLATION
NOTE
Loosen left- and right-side tunnel insulation.
(Refer to TM 9-2320-280-20.)
31-1.
Route antenna cable (1) and power cable (2) from left side of mounting base (11), down through
center access hole (4), under integrated rack (5), and under right-side tunnel insulation (7) towards
rear of vehicle.
31-2.
Route antenna cable (10) from mounting base (11) to MT-6353/VRC mounting base (9).
31-3.
Route power amp cable (3) from MT-6353/VRC mounting base (9) up through center access
hole (4) and connect power amp cable (3) to W1J1 cable (3.1).
31-4.
Route control cable (8) from MT-6353/VRC mounting base (9) up through center access hole (4) to
mounting base (11).
31-5.
Route antenna cable (6) from front of MT-6353/VRC mounting base (9), under integrated rack (5),
and under right-side tunnel insulation (7) towards rear of vehicle.
1
8
11
4
10
6
9
3
2
5
1
2
7
6
~
~
~
~
1. ANTENNA CABLE – A3014031-8 – QTY. 1
2. SINCGARS POWER CABLE – A3014039-2 – QTY. 1
6. ANTENNA CABLE – A3014031-17 – QTY. 1
10. ANTENNA CABLE – A3014032-3 – QTY. 1
Figure 5-87.
Change 1
3.1
Back to Top
