TB-9-2320-280-35-15
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11
SEPTEMBER 2006
TB-9-2320-280-35-15 - Page 120 of 168
5-96
TB 9-2320-280-35-15
NOTE
Perform step 39-4 for vehicles with left rear cab enclosure panel
only.
39-4.
Cut 2x2 in. section (13) from left rear cab enclosure panel (11). Install grommet (12). Reinstall cab
enclosure panel (11). (Refer to TM 9-2320-280-20.)
39-5.
Locate, mark, and drill three 0.147-in. holes (8) along tunnel edge (9).
39-6.
Route INC-EPUU cable (1) and power cable (4) rearward under left-side B-beam (10) and along
tunnel edge (9).
39-7.
Route INC-EPUU cable (1) and power cable (4) rearward along tunnel edge (9) and secure with
three clamps (7) and self-tapping screws (6).
Back to Top
