TB-9-2320-280-35-15

TECHNICAL BULLETIN

INSTALLATION INSTRUCTIONS FOR RETRANSMISSION VEHICLE WITH AMTECH TOP FOR AN/VRC-92F, AN/UYK-128 (V)4, RT-1812, AN/VSQ-2 (V), AB-1386/U, DAGR, AN/PSN-11

SEPTEMBER 2006

TB-9-2320-280-35-15 - Page 122 of 168

5-98

TB 9-2320-280-35-15

39-8.

Locate, mark, and drill one 0.225-in. hole (22) in inboard corner on rear inside lip of left rear seat

back support (19).

39-9.

Locate, mark, and drill two 0.147-in. holes (24) in front face of left rear wheelwell (17).

39-10.

Route EPLRS cables (16), (1), and (4) along rear perimeter of left rear seat back support (19), up

front face of left rear wheelwell (17), and under antenna base (30).

39-11.

Route NTDR antenna cable (31) down antenna base (30) to left rear wheelwell (17).

39-12.

Route NTDR antenna cable (31) along top of left rear wheelwell (17), and down front face of left

rear wheelwell (17).

39-13.

Route NTDR antenna cable (31) along left rear seat back support to multi-net rack.

39-14.

Secure cables (16), (1), (4), and (31) to left rear wheelwell (17) with screw (23), lockwasher (21),

nut (20), two self-tapping screws (18), two existing screws (14), and five loop clamps (15).

39-15.

Route cables (1) and (4) to EPLRS mount (33)

39-16.

Secure antenna cables (16) and (31) to antenna base (30) with existing loop clamps (29),

screws (25), washers (26), lockwashers (27), and nuts (28).

39-17.

Connect EPLRS antenna cable (16) to EPLRS antenna (32).

39-18.

Connect NTDR antenna cable (31) to NTDR antenna.

39-19.

Take slack out of EPLRS cables (16), (1), and (4) and store under EPLRS mount (33).

39-20.

Take slack out of NTDR antenna cable (31) and store under NTDR mount.

39-21.

Tighten all screws and nuts on all clamps.

39-22.

Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)