TB-9-2320-302-13-P-1
CREW PROTECTION KIT PART 1 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS
NOVEMBER 2006
TB-9-2320-302-13-P-1 - Page 46 of 380
TB 9-2320-302-13&P-1
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-4
2
Before
Side Armor
(Left Side)
a. Inspect A-pillar armor panels for
damage or loose or missing mounting
hardware.
Any panel or armor plate is damaged,
bent out of shape, misaligned, loose or
missing, or mounting bolts are loose or
missing.
b. Inspect A-pillar armor panels for
areas of rust or corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
c. Inspect A-pillar armor panels for
cracks near or elongation of bolt
holes.
Any cracks that are longer than 1” or
two consecutive bolt holes that are elon-
gated.
d. Inspect A-pillar armor panels for any
holes or gouges.
Any complete penetration of the armor
(hole in the armor) or multiple gouges
1/4” or deeper within 3” of each other.
e. Inspect door ballistic glass mounting
hardware for damage, loose, or miss-
ing mounting hardware.
Any ballistic glass mounting hardware
is damaged, loose, or missing, or
mounting bolts are loose or missing.
f. Inspect exterior surface of door ballis-
tic glass for rock chips, cracks,
scratches, pitting, any hits that expose
glass below the first layer, cloudiness,
or any stickers that impair vision.
Rock chips, cracks with spider webbing,
scratches, pitting, or hits in the exterior
layer of ballistic glass that expose glass
below the first layer, cloudiness that
impairs vision.
g. Inspect fender armor and support for
damage or loose or missing mounting
hardware.
Any panel or armor plate is damaged,
bent out of shape, misaligned, loose or
missing, or mounting bolts are loose or
missing.
h. Inspect fender armor and support for
areas of rust or corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
i. Inspect fender armor and support for
cracks near or elongation of bolt
holes.
Any cracks that are longer than 1” or
two consecutive bolt holes that are elon-
gated.
j. Inspect fender armor and support for
any holes or gouges.
Any complete penetration of the armor
(hole in the armor) or multiple gouges
1/4” or deeper within 3” of each other.
k. Open door and enter cab. Close door
using grab handle. Make sure door
closes without binding and locks cor-
rectly (WP 0004 00).
Door binds or does not lock.
l. Make sure door ballistic glass can
open, close, and securely lock.
Door ballistic glass will not close or
lock.
Item
No.
Interval
Location
Procedure
Not Fully Mission
Capable If:
Item To
Check/
Service
Back to Top
