TB 9-2320-302-13&P-1
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-8
REAR AND
RIGHT
SIDE
5
Before
Rear Cab
Armor
a. Inspect rear cab armor panels for
damage or loose or missing mounting
hardware.
Any panel or armor plate is damaged,
bent out of shape, misaligned, loose or
missing, or mounting bolts are loose or
missing.
b. Inspect rear cab armor panels for
areas of rust or corrosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
c. Inspect rear cab armor panels for
cracks near or elongation of bolt
holes.
Any cracks that are longer than 1” or
two consecutive bolt holes that are elon-
gated.
d. Inspect rear cab armor panels for any
holes or gouges.
Any complete penetration of the armor
(hole in the armor) or multiple gouges
1/4” or deeper within 3” of each other.
e. Inspect escape hatch ballistic glass
mounting hardware for damage,
loose, or missing mounting hardware.
Any ballistic glass mounting hardware
is damaged, loose, or missing, or
mounting bolts are loose or missing.
f. Inspect interior surface of escape
hatch ballistic glass for rock chips,
cracks, scratches, pitting, any hits that
expose glass below the first layer,
cloudiness, or any stickers that impair
vision.
Rock chips, cracks with spider webbing,
scratches, pitting, or hits in the exterior
layer of ballistic glass that expose glass
below the first layer, cloudiness that
impairs vision.
g. Exit vehicle and inspect exterior sur-
face of escape hatch ballistic glass for
rock chips, cracks, scratches, pitting,
any hits that expose glass below the
first layer, cloudiness, or any stickers
that impair vision.
Rock chips, cracks with spider webbing,
scratches, pitting, or hits in the exterior
layer of ballistic glass that expose glass
below the first layer, cloudiness that
impairs vision.
Item
No.
Interval
Location
Procedure
Not Fully Mission
Capable If:
Item To
Check/
Service