TB-9-2320-302-13-P-1
CREW PROTECTION KIT PART 1 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS
NOVEMBER 2006
TB-9-2320-302-13-P-1 - Page 54 of 380
TB 9-2320-302-13&P-1
OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED
0009 00
0009 00-12
7
Before
Floor /Fire-
wall Armor
(Right Side)
a. Inspect right side floor and firewall
armor panels for damage or loose or
missing mounting hardware.
Any panel or armor plate is damaged,
bent out of shape, misaligned, loose or
missing, or mounting bolts are loose or
missing.
b. Inspect right side floor and firewall
armor panels for areas of rust or cor-
rosion.
Any corrosion where area is unsound
and small pin holes are present, or a
rusted through condition is present.
c. Inspect right side floor and firewall
armor panels for cracks near or elon-
gation of bolt holes.
Any cracks that are longer than 1” or
two consecutive bolt holes that are elon-
gated.
d. Inspect right side floor and firewall
armor panels for any holes or gouges.
Any complete penetration of the armor
(hole in the armor) or multiple gouges
1/4” or deeper within 3” of each other.
8
Weekly
Front Sus-
pension
Inspect front suspension springs and
mounting hardware for cracks, breaks,
or loose or missing hardware and/or
shackles. Notify your supervisor of any
damage found.
Any cracks, breaks, or loose hardware
or damage to suspension springs is
noted.
9
Weekly
Cab Mounts
Inspect cab mounts for evidence of dete-
rioration, over compression or loose
mounting hardware. Notify your super-
visor of any damage or looseness found.
Deterioration, over compression, or
loose mounting hardware is noted.
Item
No.
Interval
Location
Procedure
Not Fully Mission
Capable If:
Item To
Check/
Service
Back to Top
