TB-9-2320-302-13-P-1
CREW PROTECTION KIT PART 1 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS
NOVEMBER 2006
TB-9-2320-302-13-P-1 - Page 86 of 380
TB 9-2320-302-13&P-1
CAB SUPPORT REINFORCEMENT REPLACEMENT - CONTINUED
0017 00
0017 00-2
REMOVAL
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
1.
Use lifting device to raise rear of cab enough to
remove weight from cab support reinforcement (2).
2.
After air pressure has been bled, disconnect air line (1)
from rear end of air tank located under left side of the
cab.
3.
Remove two bolts (6), washers (5), clamp bars (4),
and cab support reinforcement (2) from vehicle.
4.
Remove two rubber insulators (3) from vehicle frame.
Back to Top
