TB-9-2350-277-40-P-1
CARRIER, MORTAR, 120-MM M121, SELF-PROPELLED M1064A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 1 OF 4
JUNE 2009
TB-9-2350-277-40-P-1 - Page 38 of 100
TB 9-2350-277-40&P-1
INSTALLATION PROCEDURES – Continued
0005 00
0005 00-2
1.
Route three stoplight-taillight circuit leads; circuit 21 lead (9), circuit 22 lead (8), and circuit 24
lead (7) thru gasket (12) and CREW II mount assembly (1).
Secure stoplight-taillight (11) to
CREW II mount assembly (1) with two screws (6) and lockwashers (5).
NOTE
Do not tighten hardware until installation is complete.
2.
Position CREW II mount assembly (1) on top of left fuel tank and secure using two screws (2),
lockwashers (3), and washers (4).
3.
Attach right bottom of CREW II mount assembly (1) to fuel tank with screw (10), lockwasher (3),
washer (4), and lockwasher (5).
4.
Secure left bottom of CREW II mount to fuel tank with screw (10), lockwasher (3), and washer (4).
5.
Connect three stoplight-taillight circuit leads; circuit 21 lead (9), circuit 22 lead (8), and circuit 24
lead (7) to stoplight-taillight (11).
Figure 1.
CREW II Mount Assembly Installation
Back to Top
