TB-9-2350-277-40-P-1
CARRIER, MORTAR, 120-MM M121, SELF-PROPELLED M1064A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 1 OF 4
JUNE 2009
TB-9-2350-277-40-P-1 - Page 28 of 100
TB 9-2350-277-40&P-1
REMOVAL PROCEDURES – Continued
0003 00
0003 00-4
REMOVE SINCGARS ANTENNA/ANTENNA COVER
NOTE
If carrier has a SINCGARS antenna mounted, do Steps 1-4.
If carrier
has no antenna, go to Step 5.
1.
Remove four screws (24) and lockwashers (31) from antenna base (25).
2.
Lift antenna base (25).
Remove screw (28), lockwasher (27), and disconnect antenna ground
wire (26).
Discard lockwasher.
3.
Disconnect antenna cable (30) from antenna base (25).
4.
Remove antenna base (25) and gasket (29).
Discard gasket.
Scrape any remaining gasket
material from mating surface and clean with cleaning compound.
Figure 3.
SINCGARS Antenna Removal
Back to Top
