TB-9-2350-277-40-P-1
CARRIER, MORTAR, 120-MM M121, SELF-PROPELLED M1064A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 1 OF 4
JUNE 2009
TB-9-2350-277-40-P-1 - Page 27 of 100
TB 9-2350-277-40&P-1
REMOVAL PROCEDURES – Continued
0003 00
0003 00-3
REMOVE FUEL TANK ANGLE BRACKETS
NOTE
If angle bracket is welded to fuel access cover, it is considered an
unauthorized modification and the fuel cover and bracket must be
replaced.
Refer to TM 9-2350-277-24P and TM 9-2350-277-20-2.
1.
Remove two screws (19), lockwashers (20), washers (21) and angle bracket (22) from left fuel
tank (15).
Save angle bracket for reinstallation.
Discard screws, lockwashers, and washers.
2.
Remove three screws (18), lockwashers (17), and washers (16) from left fuel tank access cover
(23).
Discard screws, lockwashers, and washers.
Figure 2.
Fuel Tank Angle Bracket Removal
Back to Top
