TB-9-2350-277-40-P-1
CARRIER, MORTAR, 120-MM M121, SELF-PROPELLED M1064A3
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 1 OF 4
JUNE 2009
TB-9-2350-277-40-P-1 - Page 40 of 100
TB 9-2350-277-40&P-1
INSTALLATION PROCEDURES – Continued
0005 00
0005 00-4
INSTALL GPS, RCU, AND PRIMARY POWER CABLES
1.
Position gasket (24) and cable adapter seal (21) over primary unit cable port (25) with indentation
(23) of adapter seal facing the middle rear of carrier.
2.
Temporarily mount cable adapter seal (21) to hull using two screws (22) until cables are routed
and secured.
Figure 3.
Cable Adapter Seal Installation
Back to Top
