TB-9-2350-277-40-P-3
CARRIER, MECHANIZED SMOKE OBSCURANT M58
TECHNICAL BULLETIN; INSTALLATION OF CREW II MODIFICATION KIT PART 3 OF 4
JUNE 2009
TB-9-2350-277-40-P-3 - Page 33 of 88
TB 9-2350-277-40&P-3
MODIFICATION PROCEDURES – Continued
0004 00
0004 00-5/6 blank
NOTE
Do not secure cables with tie straps until installation is complete and
the cables have been adjusted at both ends.
3.
Route SINCGARS antenna cable (8) from radio unit up the turbine housing wall to the roof.
4.
Continue routing cable (8) along exiting wiring harness and around the front of the turbine
housing to the right front of the vehicle and through new hull opening (9).
5.
Secure cable (8) to existing wiring harness with tie strap (10).
6.
Loop excess cable (8) at hull opening and secure with tie strap (10).
Figure 4.
SINCGARS Antenna Cable Routing After Modification
END OF WORK PACKAGE
Back to Top
