TB-9-2510-251-13
TECHNICAL BULLETIN
OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING
AUGUST 2007
TB-9-2510-251-13 - Page 60 of 624
2-44
TB 9-2510-251-13
(25)
Install new AC/power steering belt as shown.
WARNING
Solvent used to clean parts is potentially dangerous to personnel and property.
Clean parts in a well-ventilated area.
Avoid inhalation of solvent fumes.
Wear
goggles and rubber gloves to protect eyes and skin.
Wash exposed skin
thoroughly.
DO NOT smoke or use near open flame or excessive heat.
Failure to
observe this warning could result in severe injury or death to personnel.
40
42
39
41
43
AIR CONDITIONER
COMPRESSOR
NEW IDLER
PULLEY
ALTERNATOR
POWER
STEERING
CRANKSHAFT
TENSIONER
PULLEY
EXISTING
IDLER PULLEY
WATER PUMP
2-1.2
Installation of Air Conditioning Kit to M1097A2 with GSIE Add-on-Armor (Cont’d).
a. Install Compressor (Cont’d).
Figure 2-62.
AC/Power Steering Belt
Figure 2-63.
Adjusting Arm Installation
(26)
Clean mounting surface where adjusting arm mounts to water pump housing with solvent
(item 10, Appendix D).
(27)
Secure adjusting arm (38) to water pump housing with bolt (39), lockwasher (40),
washer (41), and washer (42).
(28)
Adjust tension on belt (43).
Rotate compressor outboard until proper belt tension is
reached.
38
Back to Top
