TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 258 of 704
TB 9-3950-253-13&P
0024-2
0024
REMOVAL
00024
1. Attach sling and lifting device to stowage guide (Figure 1, Item 1).
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear and that no surfaces are slippery. Wear suitable gloves
and hard hat. Failure to follow this warning may result in injury to personnel.
2. Remove snap ring pin (
Figure 1
, Item 3), pivot pin (
Figure 1
, Item 2), and stowage cylinder (
Figure 1
, Item 8),
from stowage guide (
Figure 1
, Item 1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel.
NOTE
Stowage guide weighs 107 lb (49 kg).
3. Remove two grease fittings (
Figure 1
, Item 5) from pivot pins (
Figure 1
, Item 4).
4.
Remove two spring pins (
Figure 1
, Item 6) and pivot pins (
Figure 1
, Item 4) from stowage guide (
Figure 1
,
Item 1).
Back to Top
