TM-3-1040-279-12-P
GENERATOR SET, SMOKE, MECHANICAL: PULSE JET, M157 W/120 GAL FOG OIL TANK AND W/80 GAL FOG OIL TANK
TECHNICAL MANUAL; OPERATOR’S AND ORGANIZATIONAL MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST AND DEPOT MAINTENANCE REPAIR PARTS
MAY 1987
TM-3-1040-279-12-P - Page 37 of 389
Item
No.
8
(cont)
9
TM 3-1040-279-12&P
Table 2-1. Operator Preventive Maintenance Checks and Services (cont)
Interval
BEFORE,
AFTER
BEFORE,
AFTER
DURING
d. Monitor SMOKE TEMP
indicator for overheating.
DURING
e. Monitor indicators for
Location
Item to Check/
Service
Control Panel
Assembly
(cont)
Fuel
Filter/Water
Separator
Assembly
Procedure
b.
Set circuit breaker CB 1
and POWER switches (P.
2-3) to ON and press all
indicator lights to test.
Replace indicator and
panel lights if required.
Notify organizational
maintenance if indicator or
panel lights do not light.
NOTE
If panel lights do not light,
check panel light control knob.
Ensure that both M54 Smoke
Generators are hooked
together electrically before
performing the following
check.
c.
Place and hold FIRE TEST
switch to TEST position.
Check that the fire warning
light comes on within 2
seconds. Release switch
when light comes on or
after 2 seconds. Set circuit
breaker CB 1 and POWER
switch to OFF.
proper system operation.
WARNING
System contains combustible
fluids. Keep flames, sparks,
and ignition sources 100 feet
away at all times. No smoking
within 100 feet. Have fire ex-
tinguisher available at all
times. Fires may result in per-
sonnel injury and loss of
equipment/system.
Not Fully
Mission
Capable If:
Indicators do not light.
FIRE WARNING light does not
come on.
Change 4
2-10.3
Back to Top
