TM-5-2350-377-14-P

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)

TM-5-2350-377-14-P - Page 176 of 335

TM 5-2350-377-14&P

HYDRAULIC HOSE REPLACEMENT - continued

NOTE

Step 3 applies to Figure 66.

3. Secure two blade folder hoses (item 1) with two clamps (item 2), one flat washer

(item 3), new lock washer

(item 4), and screw (item 5) to hole on hull member (item 6).

Figure 66.

Blade Folder Hose Clamps (2 of 2).

NOTE

Be sure to install blade folder hose, from top flow valve, port 2, through top access hole in hull

and t0 top apron hose.

Steps 4 through apply to Figure 67.

4. Route two blade folder hoses (item 1) from inside to outside vehicle through access holes in hull

as shown in

(item 13).

5. Install adapter and o-ring (item 2) and quick-disconnect coupler (item 3) to blade folder hose (item 1).

6. Install adapter O-ring(item 2) and quick-disconnect coupler (item 12) to blade folder hose (item 1).

7. Connect blade folder hose (item 1) to apron hose (item 4) from top hole on apron (item 10).

8. Connect blade folder hose (item 13) to apron hose (item 11) from bottom hole on apron (item 10).

NOTE

Make sure apron hoses have minimum slack between clamps and apron when

apron is in down position.

9. Secure apron hoses (items 4 and 11) with two clamps (item 8), one flat washer (item 7), lock washer (item 6), and

screw (item 5) to boss (item 9).

0027 00-5

0027 00