TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 168 of 335
TM 5-2350-377-14&P
HYDRAULIC INTERMEDIATE MANIFOLD AND FITTINGS REPLACEMENT - continued
15. Remove five adapters (item 35) and packings (item 34) from bottom of manifold (item 16). Discard packings
(item 34).
16. Remove tee (item 5), adapter (item 3), packing (item 23), fitting (item 21), packing (item 22),
from rear of manifold
(item 16). Discard packings (item 22).
ASSEMBLY
INSTALLATION (LEFT SIDE)
NOTE
Installation procedures for right side manifold, reference TM 5-2350-262-20-2, Hydraulic
Intermediate Manifolds and Fittings Replacement, Removal (Right Side).
Procedures below
are for left side only.
Class III leaks can occur if hydraulic lines and fittings are improperly installed or not fully
serviceable. Refer to TM 5-2350-262-20-1 when replacing of repairing hydraulic system
components. Always inspect system lines, fittings, and packings for serviceability before
installation.
Do not tighten fittings until alignment with tube is checked.
Use two wrenches when connecting hydraulic lines to fittings.
Apply lubricating oil to packings prior to installation.
Steps 1 through 4 apply to Figure56.
1. Install five new packings (item 34) on five adapters (item 35), and install adapters (item 35) on bottom of manifold
(item 16).
Figure 56. Manifold Tubes.
2. Install three new packings (item 22) on two adapters (item 3) and fitting (item 21), and install adapters ( item 3), fitting
(item 21), and tee (item 5) on rear of manifold (item 16).
0026 00
0026 00-5
21
31
25
22
16
24
16
33
35
34
22
3
23
3
5
32
REAR
TOP
FRONT
Back to Top
