TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 159 of 335
TM 5-2350-377-14&P
HYDRAULIC VALVES REPLACEMENT - continued
Figure 51.
Flow Valves.
Note
Steps below apply to Figure 51.
1. Remove flow valve (item 7) from each valve body (item 4).
CAUTION
Be ready to secure valves located under brackets when removing fastening hardware.
Failure
to
do so may cause damage to equipment.
2. Holding valve removal:
a. Remove two screws (item 3), four flat washers (item 1), two lockwashers (item 10), nuts (item 6), and valve
bodies (item 8) from bracket (item 9).
Discard lockwashers.
b. Remove valve (item 12) and check valve (item 11) from each holding valve body (item 8).
ASSEMBLY
1. Flow valve installation:
a. Install two flow valves (item 7) to valve bodies (item 4).
12
11
12
11
3
1
8
3
1
2
1
3
2
7
4
5
7
4
1
6
8
1
10
10
6
6
9
0024 00
0024 00-2
Back to Top
