TM-5-3805-264-13-P

TRUCK, DUMP, HEAVY, BODY M917A1 AND M917A2

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2014

TM-5-3805-264-13-P - Page 251 of 660

INSTALLATION

WARNING

Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings

must be in good condition and of suitable capacity. Keep clear of parts supported only by

lifting device. Failure to comply may result in personnel injury, death, and/or damage to

equipment.

1.

Raise cab shield (Figure 2, Item 1) to dump body (Figure 2, Item 6).

2.

Install two screws (Figure 2, Item 3), four washers (Figure 2, Item 4), and two new locknuts

(Figure 2, Item 5) on top of cab shield (Figure 2, Item 1) and dump body (Figure 2, Item 6).

3.

Install six screws (Figure 2, Item 7), 12 washers (Figure 2, Item 8), and six new locknuts (Figure 2, Item 9)

on outside edges of cab shield (Figure 2, Item 1) and dump body (Figure 2, Item 6).

4.

Remove lifting slings (Figure 2, Item 2) from cab shield (Figure 2, Item 1).

5.

Raise and support dump body on body props (WP 0005).

6.

Install six screws (Figure 2, Item 7), 12 washers (Figure 2, Item 8), and six new locknuts (Figure 2, Item 9)

on center of cab shield (Figure 2, Item 1) and dump body (Figure 2, Item 6).

7.

Torque 12 locknuts (Figure 2, Item 9) and two locknuts (Figure 2, Item 5) to 150 lb-ft (203 N•m).

Figure 2.

Cab Shield Installation.

END OF TASK

TM 5-3805-264-13&P

0039

0039-3