TM-5-5420-202-10
LAUNCHER, M48A5 TANK CHASSIS
OPERATOR'S MANUAL
DECEMBER 2009
TM-5-5420-202-10 - Page 438 of 535
0066
TM 5-5420-202-10
11
.Use6inch f at-tipped screwdriver to install four screws (Figure 14, Item 2) and new lockwashers (Figure 14,
Item 3) in cover (Figure 14, Item 1).
Figure 14.
Headlight Cover Screw Removal.
12.Turn MASTER BATTERY switch ON. Refer to WP 0004.
13.Check operation of taillights. Refer to WP 0008.
END OF TASK
Taillight Installation
1. Install new service taillight and stoplight lamps (Figure 15, Item 4) in sockets (Figure 15, Item 9) and blackout
marker lamp (Figure 15, Item 3) in socket (Figure 15, Item 2). Press lamps in and turn clockwise to lock.
2. Wipe retainer lens (Figure 15, Item 6) with a clean cloth.
3. Inspect O-ring (Figure 15, Item 5) for cuts or damage. Notify f eld maintenance if replacement is required. Install
O-ring in retainer lens (Figure 15, Item 6).
4. Use 6 inch f at-tipped screwdriver to install retainer lens (Figure 15, Item 6) on housing (Figure 15, Item 1).
5. Use 6 inch f at-tipped screwdriver to tighten six screws (Figure 15, Item 7) and retainer rings (Figure15,
Item 8) in retainer lens (Figure 15, Item 6).
6. Turn MASTER BATTERY switch ON. Refer to WP 0004.
7. Check operation of taillights. Refer to WP 0008.
0066-10
INSTALLATION - CONTINUED
Headlight and Blackout Marker Lamp - Continued
Back to Top
