TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 126 of 734

TRANSMISSION OIL COOLER SCREEN REPLACEMENT (Sheet 1 of 2)

TOOLS:

1/2 in. socket with 1/2 in. drive

5 in. extension with 1/2 in. drive

Ratchet with 1/2 in. drive

1/2 in. combination box and open end wrench

3/4 in. combination box and open end wrench

PRELIMINARY PROCEDURES:

Remove both air cleaner outlet hose assemblies (page 7-84)

Remove powerplant (page 5-2)

NOTE

Left side-shown, right side similar.

REMOVAL:

NOTE

If removing 2A engine screen, go to step 6.

1.

2.

3.

4.

5.

6.

TM 5-5420-202-20-2

Using socket, extension, and ratchet through

harness and into bracket, remove two

assembled washer screws (A).

NOTE

You will have bracket (B) and tube

(C) only if your vehicle is equipped

with a 2DA engine.

Using socket and 1/2 inch wrench, remove

screw (D) and locknut (E) securing clamp

(F) and tube (C) to bracket (B).

Using 3/4 inch wrench, remove bolt (G).

Using socket, remove assembled washer screw

(H), screw (J), and washer (K) securing bracket

(B) and oil cooler screen (L).

Remove bracket (B) and oil cooler screen (L).

For 2A engine; using socket, remove four

screws (J) and four washers (K) securing oil

cooler screen (L). Remove oil cooler screen

(L).

Go on to Sheet 2

Change 1

6-53