TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 133 of 734

TM 5-5420-202 -20-2

ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 4 of 4)

5.

6.

7.

8.

Using 1-1/2 inch wrench, install hose

(E) to fitting (F).

Using screwdriver and 3/8 inch wrench,

install clamp (G) on hose (E) if removed

during disassembly.

Position new sealing washer (H) over vent

hole.

Using 9/16 inch wrench install and tighten

vent capscrew (J) through washer (H).

9.

Using socket and torque wrench, tighten

drain valve (K) to a minimum of 150 lb-

in. (17 NŽm). Do not overtighten.

10.

11.

12.

13.

14.

Perform ground hop (page 5-25). Run engine

at idle until oil temperature is in normal

operating range (TM 5-5420-202-10).

Shut down engine and wait 5 minutes.

Check oil level, add oil as required

(LO 5-5420-202-12).

Disconnect ground hop kit (page 5-40).

Install powerplant (page 5-14).

End of Task

6-60