TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 132 of 734

ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 3 of 4)

10.

Remove and discard gasket (K) under

connector (G).

CLEANING AND INSPECTION:

1.

2.

3.

4.

Cleaning agent specified is flam-

mable. Use only in well ventilated

areas. Keep away from flames,

sparks, or heat. Do not smoke

while using. Prevent contact with

eyes, mouth, and/or skin. Wear

rubber gloves when performing

cleaning procedures.

Using dry cleaning solvent, clean hose (E)

and connector (G).

Replace connector (G) if cracked or

broken.

Inspect threads on hose (E) and connector

(G). Replace as required.

Replace hose (E) if woven shielding

is worn or broken.

INSTALLATION:

1.

2.

3.

4.

Position new gasket (A) on oil cooler

(B).

Position connector (C) over gasket

(A).

Using 1/2 inch wrench, install three

new locknuts (D).

Using 1-1/2 inch wrench install hose

(E) to connector (C).

Go on to Sheet 4

TM 5-5420-202-20-2

6-59