TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 249 of 734

TM 5-5420-202-20-2

TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)

REPLACEMENT (Sheet 4 of 5)

2.

3.

4.

Using fingers, install bulkhead elbow (C)

in hole in front side of engine bulkhead.

Using 3/4 inch wrench to hold bulkhead

elbow (C) and 1 inch wrench install washer (D),

lockwasher (E), and nut (F) on bulkhead

elbow (C).

Using 3/4 inch wrench, turn bulkhead elbow

(C) until alined with hose assembly (G).

Tighten nut (F).

5. Using 1 inch wrench to hold nut (F) and 7/8

inch open end wrench, install tube assembly

(A) on bulkhead elbow (C).

6. Using 7/8 inch wrench, install hose assembly

(G) on bulkhead elbow (C).

Go on to Sheet 5

7-32