TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 463 of 734

TM 5-5420-202-20-2

FuEL-WATER SEPARATOR OPERATIONAL TESTS (Sheet 6 of 11)

15-Second Drain Test (Sheet 1 of 2)

1.

2.

3.

4.

5.

6.

7.

Using 1/2 inch wrench, close bleed valve (A).

Using adjustable wrench, remove pipe plug from upper sensor hole (B).

Check to see if fluid level is at top of upper sensor hole (8). If fluid level is

at top, go to step 8, if not go to step 4.

Be very careful not to disturb center filter element. The

center filter element must be replaced if disturbed in

any way.

Using 5/16 inch wrench, install pipe

plug into upper sensor hole (B).

Using 7/16 inch wrench, remove eight

screws, lockwashers, and flat washers (C)

securing cover (D) to separator (E).

Remove cover (D) from separator (E).

Add fuel to fuel-water separator (E)

until fluid level is above upper sensor

hole (B).

Place cover (D) in position and,

using 7/16 inch wrench, install

eight screws, lockwashers, and

flat washers (C).

Go on to Sheet 7

7-228