TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 465 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (Sheet 8 of 11)

Sequential Drain Test (Sheet 1 of 4)

1.

Using 5/16 inch wrench, remove pipe plug from upper sensor hole (A).

2.

Check to see if fluid level is at top of upper sensor hole (A). If fluid level is at

top, go to step 8.

If not go to step 4.

3.

Using 5/16 inch wrench, install pipe plug in upper sensor hole (A).

CAUTION

4.

5.

6.

7.

Be very careful not to disturb center filter element. The

center filter element must be replaced if disturbed in

any way.

Using 7/16 inch socket, remove eight screws,

lockwashers, and washers (B) securing cover

to separator (D). Remove cover (C) from

separator (D).

Add fuel to fuel-water separator (D)

until fluid level is above upper sensor

hole (A).

Using 5/16 inch wrench, install pipe plug

into upper sensor hole (A).

Place cover (C) in position and, using 7/16

inch wrench, install eight screws, lockwasher

and washers (B).

Go on to Sheet 9

7-230