TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 460 of 734

TM 5-5420-202-20-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (Sheet 3 of 11)

Manual Drain Test (Sheet 2 of 2)

13.

14.

15.

16.

17.

There is a gasket located between fuel-water separator

cover and fuel-water seperator body. Each time cover

is removed care must be taken not to disturb gasket.

If fluid level in fuel-water separator (A)

is not above upper sensor (B) hole, using

7/16 inch socket, remove eight screws,

lockwashers, and washers (J) securing cover

(K) to separator (A).

Remove cover (K).

Add fuel to fuel-water separator (A) until fluid

level is above upper sensor (B) hole.

Place cover (K) in position and, using 7/16

inch wrench, install eight screws, lockwashers,

and washers (J).

Using 7/16 inch wrench, open bleed valve (L)

by turning counterclockwise.

Go on to Sheet 4

18.

19.

20.

21.

Place metal container (M) under outlet

of manual drain valve (N).

Open manual drain valve (N) by turning

valve handle (P) counterclockwise. Allow

small amount of fluid to drain into metal

container (M).

If fluid does not drain, refer to trouble-

shooting sympton 10 (page 4-247).

If fluid does drain, close manual drain valve (N) and

go on to automatic drain test on next page.

7-225