TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 412 of 1060

BASKET WIRING HARNESS DISCONNECT (Sheet 4 of 4)

NOTE

The following instructions show

how to install the top wiring

connectors on the basket dis-

connect. Installation is the same

for all wiring harnesses.

NOTE

Check wiring diagram on sheet 3

for correct mating of connectors.

1.

Place connector (A) in proper position

with connector key at top on front side

of basket disconnect.

2.

Using flat-tip screwdriver, install four

screws and new lockwashers (B) securing

connector (A) to basket disconnect.

3.

Mate connector (C) onto connector

(A) at back side of basket disconnect.

4.

Using spanner wrench, tighten nut (D)

securing connector (C) on back side

of basket disconnect.

5.

Install other connectors as required

using the same procedure as steps 3

and 4.

6.

Connect three ground straps at batteries

(page 10-268).

End of Task

TM 5-5420-202-20-3

10-296.72

Change 7