TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 802 of 1060

ROADWHEEL ARM REPAIR (Sheet 9 of 9)

TM 5-5420-202-20-3

15.

16.

17.

17.1

18.

19.

20.

21.

22.

Apply grease to bearing spacer (E) and bearing washer (F).

Install bearing spacer (E) onto spindle up against outboard bearing (C),.

Repeat step 14 to install inboard bearings (D).

Install bearing washer (F) onto spindle up against inboard bearing (D) with step side of washer (F)

facing bearinga (D).

Install key washer (G) on spindle of arm so that inside tab fits into groove.

NOTE

Make sure outer tabs of key washer are pointing towards nut (H).

Screw nut (H) onto threaded end of spindle.

Using spanner wrench, tighten nut (H) until

parts on spindle cannot be turned by hand.

Back off nut (H) just enough so parts can be

turned by hand through one complete turn on

spindle.

Using pliers, bend tab on key washer (G) into

alining slot on nut (H).

23.

Install roadwheel arm (page 14-6).

End of Task

Change

4

14-14.3/(14-14.4

blank)