TM-5-5420-202-20-4
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4
OCTOBER 1985
TM-5-5420-202-20-4 - Page 106 of 534
TM 5-5420-202-20-4
PERSONNEL HEATER REPAIR (Sheet 4 of 8)
Heater Igniter Replacement (Sheet 4 of 4)
TEST:
1.
If burner is flooded (see INSPECTION OF
IGNITOR WICK), disconnect lead (A) at
normally open (N.O.) terminal on flame
detector switch (B).
2.
Install personnel heater igniter (C), electrical inlet connection (D), and electrical con-
nector (E). See INSTALLATION procedure.
7.
Once this has happened, connect lead
(A) to flame detector switch (B).
8.
Install personnel heater cover (page 18-9,
steps 6 and 7).
9.
Let personnel heater run for 5 minutes.
3.
Turn PERSONNEL HEATER HEATER
MASTER switch (F) ON.
4.
Set PERSONNEL HEATER ON-HI OFF
ON-LO switch (G) to ON-LO.
5.
A white, smoke-like fuel vapor will
flow out of exhaust tube at front of
vehicle.
6.
When personnel heater ignites, wait
End of Task
for black-grey exhaust smoke to clear
up.
10.
OFF ON-LO switch (G) to OFF. ‘
--
Fan will cent inue to run until fuel is
purged from personnel heater.
TA248609
18-10
Back to Top
