TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

  TM-5-5420-202-20-4 - Page 206 of 534

TM 5-5420-202-20-4
EXTERIOR RELEASE HANDLE MOUNTING BRACKET REPLACEMENT (Sheet 1 of 2)
TOOLS:
1-1/8 in. combination box and open end wrench
1 in. combination box and open end wrench
Flat-tip screwdriver with 5/16 in. blade
SUPPLIES:
Preformed packing (two)
PRELIMINARY PROCEDURES:
Remove exterior release handle body assemblies
(page 20-39)
Remove outside release handle control assemblies
(page 20-44)
REMOVAL:
1.
Using 1-1/8 inch wrench,
nuts (A) from inside hull.
remove two
2.
Remove mounting bracket (B) from
vehicle.
3.
Using hands, remove preformed packings
(C). Throw packings away.
NOTE
4.
Using 1 inch wrench, remove couplings
When removing couplings (D) in next step,
(D) from mounting bracket (B).
bushings (E) and washers (F) will remain with
couplings (D).
5.
Using 1-1/8 inch wrench, remove nuts
(G) from mounting bracket (B).
6.
Using screwdriver, remove washers (F) and bushings (E) from couplings (D).
Go on to Sheet 2
20-48
TA248706


Back to Top