TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

  TM-5-5420-202-20-4 - Page 207 of 534

TM 5-5420-202-20-4
EXTERIOR RELEASE HANDLE MOUNTING BRACKET REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
5.
6.
7.
8.
9.
10.
CAUTION
Be sure not to overtighten couplings
(F) or tubes (G) will collapse.
Using 1 inch wrench to hold coupling
(F), use 1-1/8 inch wrench and tighten
nuts (C) against coupling (F).
Place mounting bracket (B) onto vehicle.
Screw two nuts (G) to mounting ’bracket
(B) (inside hull).
Using 1-1/8 inch wrench, tighten two
nuts (H).
Install outside release handle control
assemblies (page 20-46).
Install exterior release handle body
assemblies (page 20-41).
1.
Using hands, install new preformed
packings (A) onto bracket (B).
2.
Using 1-1/8 inch wrench, screw nuts
(C) all the way down onto bracket (B).
3.
Press bushings (D) and washers (E) into
couplings (F).
4.
Tighten couplings (F) finger tight
to bracket (B).
End of Task
TA248707
20-49


Back to Top