TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 279 of 534

TM 5-5420-202-20-4

SMOKE GENERATOR TEE-TO-TURBOSUPERCHARGER TUBE ASSEMBLY REPLACEMENT

(Sheet 4 of 5)

INSTALLATION:

1.

If adapter (A) was removed from turbosuper-

charger elbow (B), remove adapter (A)

from replacement tube and, using 1/2

inch wrench, install adapter (A) to turbosuper

charger elbow (B).

2.

If adapter (A) was not removed from

turbosupercharger elbow, remove adapter

(A) from replacement tube and return

adapter to supply.

3.

Position tube (C) to engine and manually connect it to adapter (A).

4.

Position tee (D) and manually connect tube

nuts (E) to tee (D).

5.

Position tee (D) so the open port points

toward solenoid valves (F).

6.

Using 9/16 inch wrench, tighten tube nuts

(E) onto tee (D).

7.

Using 3/4 inch wrench, install 90-degree

elbow (G) to tee (D). Position elbow open

port down.

8.

Using 11/16 inch wrench, connect solenoid

output fuel hose (H) to 90-degree elbow

(G).

9.

Using 1/2 inch wrench to hold adapter (A) in turbosupercharger elbow (B), use 9/16 inch

wrench to tighten tube (C) onto adapter (A).

Go on to Sheet 5

TA248778

21-37