TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 269 of 534

TM 5-5420-202-20-4

SMOKE GENERATOR SOLENOID REPLACEMENT (Sheet 3 of 5)

8.

9.

10.

11.

12.

Using 5/16 inch wrench, remove four

screws (M), lockwashers (N), and flat

washers (P) securing solenoid valves

(B) to bracket (L).

Remove solenoid valves (B) with fittings

as a unit.

Using 3/4 inch wrench, remove 90-degree

elbow (Q) from input port of solenoid

(B).

Using 9/16 inch wrench, remove 45-

degree elbow (R) from output port of

solenoid (B).

Using 5/8 inch wrench, remove nipple (S) from solenoid valves (B).

INSTALLATION:

1.

Check position of electrical connector on solenoid valves. Hold valve with outlet port

to your left. Electrical connector must be 45 degrees from outlet port and pointing

toward you. If connector must be repositioned, place valve in soft-jawed vise. Loosen

acorn nut on top of valve and rotate connector to correct position. Using 3/4 inch socket

and torque wrench, tighten acorn nut to 50 in-lb (5-6 N•m).

Go on to Sheet 4

TA248768

21-27