TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 271 of 534

TM 5-5420-202-20-4

SMOKE GENERATOR SOLENOID REPLACEMENT (Sheet 5 of 5)

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

Position

bracket

assembled solenoids (B) and

(E) to engine.

Using 3/4 inch socket, install and tighten

two screws (J) to secure bracket (E)

to engine.

Install lockwire (K).

Using 7/8 inch wrench, connect elbow-

to-solenoid hose (L) to 90-degree elbow

(c).

Using 11/16 inch wrench, connect output

fuel hose (M) to 45-degree elbow (D).

Manually connect electrical connectors (N) to solenoids (B).

Using 7/16 inch wrench and 7/16 inch socket, install nut and screw (P) to secure ground

wire (Q) to bracket (E).

Start engine (TM 5-5420-202-10). Run engine until normal operating temperatures are

reached. Run engine at 1600 rpm and activate smoke generator. Observe operation.

Shut down smoke generator. Shut down engine.

Check system for any possible fuel leaks.

Correct leaks as necessary.

Install engine shroud (page 9-3 1).

TA248770

21-29

End of Task