TM-5-5420-228-24
LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
AUGUST 1985
TM-5-5420-228-24 - Page 425 of 750
TM 5-5420-228-24
HEU EJECTION CYLINDER HYDRAULIC HOSES “AM”, “AN”, “AP”, “AQ”, “AW”, “AX”
REPLACEMENT (Sheet 5 of 8)
21.
Holding elbow (AE) with adjustable wrench, use wrench to disconnect hose assembly “AX” (AD) from elbow (AE)
remove bushing (AA).
22.
Using adjustable wrench, remove elbow (AE) from ejection cylinder “ED” (R), and remove preformed packing (C).
INSTALLATION:
NOTE
Remove all caps and plugs as necessary during installation.
1.
Place new preformed packing (A) on elbow (B) and use adjustable wrench to install elbow (B) into ejection cylinder
“ED” (C).
2.
Place new preformed packing (A) on elbow (D) and use adjustable wrench to install elbow (D) into ejection cylinder
“ED” (C).
3.
Place new preformed packing (A) on elbow (E) and use adjustable wrench to install elbow (E) into ejection cylinder
“ED” (F).
4.
Place new preformed packing (A) on elbow (G) and use adjustable wrench to install elbow (G) into ejection cylinder
“ED” (F).
5.
Hold elbow (B) with adjustable wrench and use wrench to install hose assembly “AW” (H) onto elbow (B).
Go on to sheet 6
3-204.24
Change 3
Back to Top
