TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 437 of 750

TM 5-5420-228-24

HEU HOSE ASSEMBLIES

"BA", "BB", "BC", "BD", "BE" OR "BF" REPLACEMENT

(Sheet 1 of 3)

PROCEDURE INDEX

P

r

o

c

e

d

u

r

e

s

P

a

g

e

Removal

3-204.36

Installation

3-204.37

TOOLS:

12-in. Adjustable wrench

Ratchet with ½ in. drive

1 5/16-in. open end wrench

9/16-in. socket with ½ inch drive

SUPPLIES:

Rags (Item 12, Appendix D)

Drip pans (suitable containers)

Pipe tape (Item 19, Appendix D)

Gloves (Item 27, Appendix D)

Dry cleaning solvent (Item 15, Appendix D) Lockwashers (as required)

Preformed packing (as required)

Protective caps and plugs (assorted sizes)

Masking tape (Item 18, Appendix D)

PERSONNEL:

2

REFERENCE:

LO-12

PRELIMINARY PROCEDURES:

Remove front quadrant (page 3-45)

Zero hydraulic pressure (page 3-70.5)

NOTE

Use this procedure to replace hose assemblies "BA", "BB", "BC", "BD", "BE" or

"BF".

Hose "BA" is shown. Refer to Inside Hydraulics schematic diagram to

identify hoses and related component connections (page 3-70.4).

REMOVAL:

1.

Use adjustable wrench to hold adapter (A), and use wrench to disconnect hose assembly “BA” (B) from manual control

valve (C).

2.

Use socket to remove six screws (D) and washers (E) from hose clamp (F).

3.

Remove split bushings (G) from hydraulic hose.

Go on to Sheet 2

3-204.36

Change 3