TM-9-1290-365-24-P

PALADIN MUZZLE VELOCITY SYSTEM M93 UPGRADED

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

OCTOBER 2000
TM-9-1290-365-24-P

  TM-9-1290-365-24-P - Page 57 of 334

ARMY TM 9-1290-365-24&P
NOTE
Failure to perform continuity check at this point may require complete
disassembly of connector to correct improperly terminated connector pins.
m. Perform continuity test of cable in accordance with para. 3.2.5. If cable checks good,
proceed to step n.
n. Using small wire brush, clean sealing compound residue from threads of connector body
(1) and backshell (2).
o. Apply primer to threads of connector body (1 j and backshell (2).
p. Apply sealing compound to threads of connector body (1 ) and backshell (2).
q. Screw backshell (2) on connector body (1) and torque to 3.7 in-Ib (5 N.m).
r. Apply S1184 adhesive to inside of boot (3) to bond with cable shield and backshell (2).
s. Apply 51125 adhesive inside of boot (3) for bonding to cable jacket (4) and backshell
(2).
t. Place boot (3) on backshell (2).
u. Using heat gun, apply heat uniformly to boot (3) until boot shrinks to form secure seal
around backshell (2) and cable (4).
3.2.5 Inspection
. Refer to Figure 3-1. Inspect Power and Data Cable (0.75-Meter) as follows:
a. Inspect all parts for damage, wear, and deterioration.
b. Inspect all wiring for bent or broken leads; cracked, frayed, deteriorated, worn,
overheated, or burned insulation, and security of attachment.
c. Inspect connectors (1,5) for broken, bent, recessed, loose, damaged, or missing pins.
3.2.6 Continuity Test
. Refer to Table 3-6 and Figures 3-2 and 3-3. Check wiring continuity as
follows:
a. Set DMM to RESISTANCE mode.
b. Set DMM to OHMS X 1 mode.
c. Zero DMM to eliminate internal resistance of DMM and resistance of test leads.
d. Measure continuity between connector plugs P1 and P2 in accordance with Table 3-6.
Resistance should not exceed 0.5 ohm.
e. Set DMM to OHMS X 10K mode.
f. Measure resistance between each connector pin and adjacent pins. Resistance should
be infinite.
g. If incorrect readings are noted in step d. or f., repair or replace wire or connector.
3-9


Back to Top