TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 113 of 552
TM 9-2320-209-20-3- 2
(2) Hydraulic hose .
CAUTIO N
Fittings are made of soft brass. They can b e
stripped very easily if tightened too much .
Tighten fittings just enough to stop fluid fro m
leaking .
NOT E
Hydraulic hose on left fron t
this typical procedure .
axle is used fo r
FRAME 1
1 .
2 .
G O
Using 5/8-inch combination box and open end box wrench, put in and hol d
tube nut (1) .
Using 15/16-inch open end wrench, screw on and tighte n
washer (2) and nut (3) .
Using 15/16-inch combination box an d
nut (3) .
Using 7/16-inch combinatio n
on and tighten tube nut (4) .
TO FRAME 2
open end bo x
box and ope n
wrench ,
end bo x
hold tub e
wrench, scre w
13-10 0
Back to Top
